How do you remove solvent under reduced pressure?, TOPTION glass reaction vessel, glass reactor, chemical glass reactor

How do you remove solvent under reduced pressure?

How do you remove solvent under reduced pressure?

In cbd oil industry, first step through extraction equipment ( supercritical co2 extraction / ethanol centrifuge extraction / ultrasonic extraction ) to get cbd crude oil from hemp. Second add suitable solvent to do dewaxing filtration, after impurities are removed, then we need to do solvent remove .
Usually you could choose rotary evaporator or wiped film evaporator to remove solvent, do how do you remove solvent under reduced pressure?

1. Concentrated under reduced pressure: remove the solvent and keep what you want. Distilled under reduced pressure: Evaporate what you want. Rotary evaporator is an economical method to remove solvent, you could choose 1~100L volume according to your request, matched with vacuum pump & chiller.

2. When you use rotary evaporator to do solvent remove under reduced pressure, first draw a small vacuum (about 0.03MPa), and then open and rotate to prevent the evaporation flask from slipping. When stopping,please wait until the vacuum drops to about 0.04MPa before stopping the vacuum pump. To prevent the evaporation flask from falling off and sucking back.

3. Each interface, sealing surface, sealing ring and joint of your rotary evaporation equipment need to be coated with a layer of vacuum grease before installation.

4. Water must be added to the heating bath of rota evaporator before power is applied.

5. If the viscosity of your sample is very large, the rotation speed should be slowed down and manually rotated slowly to form a new liquid surface to facilitate solvent evaporation .

6. When your sample is sensitive to air, a nitrogen balloon could be connected to the exhaust port. First, a burst of nitrogen is passed to exhaust the air in the rotary evaporator , and then a sample bottle is connected to rotary steam. After steaming, release nitrogen to increase the pressure, then turn off the pump, and then remove the sample bottle and seal it.
Don't know how to choose suitable vacuum system, vacuum controller, chiller low temperature circulator, want to know how to maintain your equipment, welcome contact: info@toptionlab.com free support.